• <u id="cs2us"><button id="cs2us"></button></u>
  • 快捷導航



    • 聯系電話:

    • 公司傳真:

    當前位置 :

    Notes for operation of crushing hammer

    點擊次數:   更新時間:19/11/26 16:41:11     煙臺華拓工程機械有限公司
    As an important working tool, the crushing hammer can be operated correctly to improve its work efficiency and extend the service life of the crushing hammer.

    1. Stop operation when the hose vibrates violently

    The high pressure and low pressure hoses of the crushing hammer should be checked for excessive vibration, and if that is the case, contact the local authorized designated service immediately for service. Should further check whether the hose joint oil seepage, if there is oil seepage, should re-tighten the joint.

    2. Avoid excessive air strikes

    Stop hammering as soon as the stone is broken. If the air strike continues, the bolt will loosen or break. When the breakdown force of the crushing hammer is improper or the steel bar is used as a pry bar, the phenomenon of air strike will occur.

    3, can not be used as steel bar bar

    If the steel bar is used as a crowbar, the bolt and steel bar may break.

    4. Do not continue to hit for more than 1 minute

    When hitting a hard rock, do not hit the same place for more than 1 minute, and then hit another place. A long time strike operation will cause the oil temperature to rise, which will lead to the damage of steel brazing bushing and steel brazing schedule wear.

    5. Do not use the crushing hammer to suspend the object

    Do not attach a rope to the breaking hammer to suspend the object, it is easy to damage the breaking hammer, and this operation is also dangerous.

    Above is the operation of the crushing hammer matters needing attention, when you use, to pay attention to the above problems, so as to extend its service life.

    Editor: WMM

    服務咨詢電話:于希光 134-6845-5385
    • 公司電話:17753532320
    • 公司傳真:0535-3977838
    • 公司地址:煙臺市開發區北京南路8號東方工業園B區13號